Usl JSD-100 Manuel d'installation télécharger pdf (Page 37)

SX-2000 Installation Manual

11/8/2010

GDC Technology Ltd. Page 36 of 42

Figure 39 Automation settings for JNIOR device

3.3.8 Automation setup for Christie ACT devices

The SX-2000 server supports Christie ACT automation device. Follow the steps below to

configure a Christie ACT device in the server automation interface.

Click the [Add] button on the [Devices] tab and enter the name of the device. In this

case, it is “ChristieACT”. Set the device type to “ChristieACT” (see Figure 40).

2. Click [OK] and set up the device parameters for the Christie ACT device.

3. Enter the IP address of the Christie ACT device (see Figure 41).

4. The default setting for the ‘Port’ is displayed on the settings for the Christie ACT device.

Change this value if required.

5. Default control cues will be set up for a new Christie ACT automation device. Control

cues can be added or removed by clicking on the [+] and [-] buttons.

6. Click the [Save] button to save configured settings.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42

Pas de commentaire

Usl JSD-100 Manuel d'installation Page 37