Usl JSD-100 Manuel d'installation télécharger pdf (Page 5)

SX-2000 Installation Manual

11/8/2010

GDC Technology Ltd. Page 4 of 42

Figure 3 SX-2000 server with external touchscreen LCD

2.2 Placing the Server

The SX-2000 is a 4U unit that is designed to be mounted on standard 19” racks. The server is

usually mounted to the rack in the projector pedestal, but it can also be mounted to any other

standard 19” rack or simply placed on a flat surface.

The server should be mounted with all cables completely unplugged. The screws required to

mount the server are not supplied by GDC.

It is important to make sure that the server is secured tightly to the rack and is not susceptible

to vibrations or shocks. It is also important to place the server horizontally.

2.3 Insertion of Drives

Each server is shipped with the content hard drives separate from the server. The server’s

content storage hard disks are inserted into a hot swap bay. The content storage hard disks

must be inserted into the server (in any particular order) before starting the server.

Ensure that the server is powered off before inserting a content storage drive.

2 Use the keys that are included to open the door covering the hard drive bay. The door is

located on the right side of the server’s front panel.

3 Press the open button located on the front left side of each content storage drive. This

will release the grey handle on the front of the drive.

1 2 3 4 5 6 7 8 9 10 ... 41 42

Pas de commentaire

Usl JSD-100 Manuel d'installation Page 5